Yesterday the sensors I had ordered arrived, I had ordered the Figaro TGS822 and the MQ-3 from Hanwei Electronics. Since this type of sensors require a burn-in of 24-48 hours I wired them and applied some power. I had a suspicion that the sensors were actually going to be identical in function but perhaps I was wrong since they do actually use different amounts of current. The TGS822 sensor draws 117 mA while the MQ-3 draws 102 mA. It might just be that different individuals use different amount of current, further experimenting will tell if they also measure differently.
One thing that I didn’t expect was that the pins of the sensors are placed along the side of the round sensor following the curvature. This makes it impossible to stick them into a breadboard, since the pins will not line up with the holes in the breadboard, so I had to solder some wires to the connectors.